Unlike some other pixel top hats available in the past, this one was built to stand out. Completely redesigned from the beginning to not only look good but feel good wearing without the mess of wiring and control parts sitting against your head.
- Completely 3D printed frame to support pixels.
- Internal housing to hold the Raspberry Pi.
- Long enough USB cables to allow the battery pack to be placed in your back pocket.
- And best of all, weighing in at only 18 ounces when complete!
Simple build instructions as well as access to community shared drive folder included.
Free shipping included
Visit our Google Drive here:
5v Pixel Top Hat Kit
What This Is For
A build kit for a wearable pixel top hat, using a printed support frame and an internal electronics compartment. The project combines the listed parts with a configured lighting and battery setup.
JR Recommends
Check the kit contents and build instructions before ordering the electronics. Plan battery placement and cable routing so the finished hat is comfortable and the wiring stays protected.
