Pathway Arch™ Bullet Node Clips

These Bullet Node Clips provide an elegant solution to add your pixels to 3/4" EMT, 3/4" PVC, 1" steel tubing . These specially designed clips snap on to hold a single bullet node pixel. Sold in packs of 50, these clips are made of PETG and are available in Black, White or Red.

Installation:

We recommend sliding the pixel down vertically from the top of the holder, as trying to push it in horizontally may break the arms of the clip. There is a slot on the inside of the pixel holder to allow the wiring to run close to the pipe to prevent any shadowing.

About PETG:

PETG, or glycolized polyester, is a thermoplastic combining both the simplicity of PLA 3D printing and the strength of ABS. PETG is typically used in models that need good shock resistance or some flexibility, like snap-to-fit components. PETG is water-, chemical- and fatigue-resistant. It is also more durable than PLA as well as less stiff. Most importantly, PETG is one of the most UV-resistant filament types available. This ensures that the mechanical properties of PETG won't be affected by ultraviolet rays even after years of exposure.