All Layered Up 3D

Pixel Pushing Jig Set Mattos Designs Edition

$14.99

THE ORIGINAL PIXEL PUSHING JIG SET

This is a jig used for pushing RGB pixels into Boscoyo Studios mounting strips. It will work with both the original mounting strips as well as the newer heavy duty strips. The mounting strip slides through the jig and allows you to push pixels at any spacing you desire. It has recessed holes that can be used to mount to a bench or piece of wood. This speeds up the process of inserting pixels and saves wear and tear on your thumbs/fingers.

Includes:

  • T handle pixel pusher for 12mm bullet nodes
  • 8” Boscoyo mounting strip jig
  • Made by All Layered Up3D.

Customer Reviews

Based on 1 review Write a review
Customer Reviews
5.0 Based on 2 Reviews
5 ★
100% 
2
4 ★
0% 
0
3 ★
0% 
0
2 ★
0% 
0
1 ★
0% 
0
Write a Review

Thank you for submitting a review!

Your input is very much appreciated. Share it with your friends so they can enjoy it too!

Filter Reviews:
CD
12/06/2021
Christian D.
United States

The Pixel Pushing jig was an excellent tool to push pixels into pixel strip. Most of the time I did not use the t-handle as I found it faster to push by hand. Pushed 7600 pixels through strip a lot faster than I expected, thanks to the jig.

CS
09/02/2021
Christopher S.
United States United States

Must have for pixel pushing

I tried pushing pixels without this, but quickly found out it was needed. The block was very helpful and did speed up the process.